Diamond was found in podiform chromitites of ophiolite and harzburgite from Luobusha, Tibet. There are silicate inclusions in some diamond grains from this area. In the present work, the CCD (charge coupled detector) technology of X-ray powder diffraction was applied to the study of the inclusion in diamond from the ophiolite of Tibet. Diffraction patterns are obtained even though the inclusion is only 20 μm in crystal size. The results show that the inclusion in diamond consists of talc and clinochrysotile. Therefore, it is clear that the diamond from the ophiolite of Luobusha, Tibet, is natural diamond rather than a synthetic one. 相似文献
Shallow seismic measurements in harzburgite from the Oman ophiolite performed in a zone where the maximum horizontal anisotropy is expected (vertical foliation and horizontal lineation) point to a dominant dependence of seismic properties on fracturing.
Optical microscopy studies show that microcracks are guided by the serpentine (lizardite) penetrative network oriented subparallel to the harzburgite foliation and subperpendicular to the mineral lineation, and that serpentine (lizardite) vein filling has a maximum concentration of (001) planes parallel to the veins walls. The calculated elastic properties of the oriented alteration veins filled with serpentine in an anisotropic matrix formed by oriented crystals of olivine and orthopyroxene are compared with seismic velocities measured on hand specimens.
Laboratory ultrasonic data indicate that open microcracks are closed at 100 MPa pressure, e.g. (J. Geophys. Res. 65, (1960) 1083) and (Proc. ODP Sci. Results Leg 118, (1990) 227). Above this pressure, laboratory measurements and modeling show that P-compressional and S-shear wave velocities are mainly controlled by the mineral preferred orientation. Veins sealed with serpentine are effective in slightly lowering P and S velocities and increasing anisotropy. The penetrative lizardite network does not affect directly the geometry of seismic anisotropy, but contributes indirectly in the fact that this network controls the microcrack orientations.
Comparison between seismic measurements of peridotite and gabbro in the same conditions suggest that P- and S-waves anisotropies are a possible discriminating factor between the two lithologies in the suboceanic lithosphere. 相似文献
The northern part of the western Kunlun (southern margin of the Tarim basin) represents a Sinian rifted margin. To the south of this margin, the Sinian to Paleozoic Proto-Tethys Ocean formed. South-directed subduction of this ocean, beneath the continental southern Kunlun block during the Paleozoic, resulted in the collision between the northern and southern Kunlun blocks during the Devonian. The northern part of the Paleo-Tethys Ocean, located to the south of the southern Kunlun, was subducted to the north beneath the southern Kunlun during the Late Paleozoic to Early Mesozoic. This caused the formation of a subduction-accretion complex, including a sizeable accretionary wedge to the south of the southern Kunlun. A microcontinent (or oceanic plateau?), which we refer to as “Uygur terrane,” collided with the subduction complex during the Late Triassic. Both elements together represent the Kara-Kunlun. Final closure of the Paleo-Tethys Ocean took place during the Early Jurassic when the next southerly located continental block collided with the Kara-Kunlun area. From at least the Late Paleozoic to the Early Jurassic, the Tarim basin must be considered a back-arc region. The Kengxiwar lineament, which “connects” the Karakorum fault in the west and the Ruogiang-Xingxingxia/Altyn-Tagh fault zone in the east, shows signs of a polyphase strike-slip fault along which dextral and sinistral shearing occurred. 相似文献
